Gas Control Unit

Consisting of precision two-stage regulators for regulative oxygen and fuel gas supply to the gun.

  • Gas Regulator (Acetylene):
  • Acetylene

2GFM Gas Flow Meter

  • Used for measuring the flow of Oxygen and Fuel gas and also prevent backfire.
  • 2GFM GAS FLOW METER: 2GFM GAS FLOW METER

Safety Wears

  • Metallizing Helmet: Light weight & comfortable with excellent vision. Supplied from a separate air supply which should be filtered by Helmet Air Conditioner.

  • Air Breather: This is installed in between compressed air line originating from fitting to the operators’ helmets. Activated charcoal is contained in the breather unit which separates the oil traces from the compressed air and clean compressed air is fed to the operator’s helmet.

  • Helmet Air Conditioner: Air from the air breather is fed to the helmet air conditioner and air is contained before it is fed to the helmet for breathing. It has also a regulator knob so that the operator can regulate the temperature of air fed to the helmet. It is self-driven and doesn’t need external power.

  • Ear Muff: Light weight & comfortable. Operator & other personnel close to the spray operation must wear. Protect the operator from noise originating during thermal spray.

  • Protective Glass: Light weight & comfortable with excellent vision. Operator & other personnel close to the spray operation must wear.

  • Operator Safety Mask: Ensure clean breathing air at all times. Conforms to current legislation on breathing air quality.

  • Hand Gloves: These are made of rubber and have anti-static properties. Hand gloves protect the operators’ hands against flying abrasive and static charge if any.

Air Control Unit

Consists of an Air regulator with a pressure gauge and dual air filter for regulating compressed air supply to the gun.

  • Air Control unit: Air Control unit

Vibrator

For certain fine materials or powders that are not freely flowing, the 5PVM Vibrator is available in single phase 220V AC/110 VAC

Air Jet Assembly

If additional workpiece cooling is required or if denser, harder coatings are desirable, the 2PSAAir Jet Assembly is available. Designed for attachment to the front of the 5P-II gun, it injects high-velocity air into the spray stream. Adjustable cooling tubes can be focused towards any part of the spray stream or directly onto the workpiece.

  • Length: 6 INCH/ 1 FOOT

Extension Nozzle

Extension Nozzle for the 5PM-II gun permits coating of interior bore diameters and surfaces and is available in three standard lengths:

  • 305mm – 1 Feet
  • 610mm – 2 Feet
  • 910mm – 3 Feet

Hose Kit

Standard length of High-pressure hose for oxygen and fuel gas to connect the gun with Gas Control Unit.

  • Hose Pipe: Hose Pipe